User Manual

Received values and parameter setting values The range of the value of each DSP Parameter 7
array element depends on the selected DSP or array number. Unlike manipulation of a DSP parameter
using a System Exclusive Message, a value received by this control change message is always in the range
of 0 to 127, but the range is changed in accordance with the setting range of the applicable parameter
setting. Because of this, it is imp ossible for a value to be outside of the range. Conversion to the
parameter setting value from the value received with the message can be represented in general terms
by the expression shown below.
Parameter Setting Value = Parameter Minimum Value + (Parameter Maximum Value − Parameter Minimum Value) ∗
(
Received Value
127
)
7.9 Hold1 (40H)
Message Format: BnH 40H vvH
n: MIDI Channel Number
vv: Value
Transmit Sent when a pedal that has a sustain (damper) function is operated.
Receive Receipt performs an operation equivalent to a sustain pedal operation.
Timbre Type Specific Operation This operation differs in accordance with the Timbre Type (see
“About the Timbre Type” in “8 Program Change”) setting.
• Timbre Type: Melody,Hex Layer
Sustain off/on control is performed in accordance with the value of the received message. For
information about
the relationship between setting values and send/receive values, see the 、26.2 Off/On Setting
Value Table、 in
、VII Setting Values and Send/Receive Values、.
• Timbre Type: Piano
Continuous control of the following is performed in accordance with the value of the received
message.
– Piano note decay rate
For information about the relationship between setting values and
send/receive values,
see 、26.3 Sustain Pedal Setting Value Table、 in 、VII Setting
Values and Send/Receive Values.、
• Timbre Type: LM (Linear Morphing) Piano
Continuous control of the following is performed in accordance with
the value of the received message.
– Piano note decay rate
– Resonance characteristics and decay rate of Damper Resonance effect resonance note
11