User Manual

Shutting Down the Power

This section describes various ways to turn off the power.

Select “Shut down”, “Restart”, “Stand by” or “Hibernate” from the Start

menu.

The following ways are also available.

• Slide the power switch so that the unit enters the “Stand by”,

“Hibernate” or “Shut down” mode. However, if you keep sliding the

power switch for more than 4 seconds, the system is quit forcibly and

the power is turned off (see “Preferences “ on page 90).

• Close the display panel so that the unit enters the “Stand by” or

“Hibernate” mode.

The amount of power FIVA consumes when the power is turned off and

the time until Windows Me is reactivated differs in each of these power

save modes.

Fully understand the features of each of these power save modes, and

select the mode that best suits your particular requirements.

Mode

Storage Time Unit Power

Indicator Lamp

for state Recovery Consumption

Power Off None Long (restart) Almost zero Off

Standby Memory Fast Yes Flashing

Hibernation

Hard Disk Long Almost zero Off

Note

FIVA’s default settings cause it to enter the Standby Mode if you do not

perform any key or thumb pad operation for about 10 minutes under

battery power alone. After another 10 minutes continuously without

operation, FIVA enters the Hibernation Mode.

portant

FIVA with the power source only from battery pack may not completely

recover if left in the Standby Mode for a very long time. If you do not

plan to use FIVA for a long time, turn it off or put it in the Hibernation

Mode.