User Manual

67
Software Troubleshooting
Symptom Possible Cause Required Action

Some dots of
printed text
are missing.
Text field is too
small.
Make the text field a little bigger. This
does not eliminate the problem, click
Text settings (T)... on the Settings (S)
menu. On the dialog box that appears,
select Auto (U) for the Text Alignment
setting and then try printing again. You
can also print without losing the edges
of the print area by inserting margins at
the edges.
The text is larger
than the print
area.
Reduce the size of the text. You can
also print without losing the edges of
the print area by inserting margins at
the edges.
Printing Problems
No tape comes out when I print.

The tape compartment cover is not closed securely.
Close the cover securely.
Printer User's Guide

The cartridge is out of tape.
Replace the tape cartridge with a new one.
Printer User's Guide

Tape is jammed.
Unplug the AC adaptor, and then remove the tape cartridge from the
printer and pull out the jammed tape with your fingers. Use scissors to
trim off the tape you pulled out. Next, correctly load the tape cartridge
back into the printer. Finally, connect the AC adaptor.
Important!
Do not do any of the following while printing is in progress.

Allow the tape outlet to become blocked

Touch the tape coming out of the printer

Open the tape cartridge compartment cover

Disconnect or unplug the AC adaptor

Disconnect the USB cable
Printer User's Guide
Tape comes out of the printer during printing, but nothing is printed on it.

Only margins are input.
Input the text you want to print.