User Manual

12
■ Option
Use the Option tab to configure Print Density and Print Setting
settings.
1
6
3
4
5
2
1
Print Density (D)
Adjusts the print density. Adjust this setting
when printing results are smudged or too dense.
Light: Makes printing lighter.
Dark: Makes printing darker.
2
Cut Style (R) Specifies the tape cut style.
No Cut: Auto cut disabled.
Full Cut Only: Performs a full cut after each
tape is printed.
Half Cut/Full Cut: Performs a half cut after
each tape is printed, and a full cut after all of
the tapes are printed.
3
Margin (S) Specifies the length of leading and trailing
margins.
Small: Margins of approximately 3 mm each.
Medium:
Margins of approximately 10 mm each.
Large: Margins of approximately 21 mm each.
4
Save Tape (M)
Select this check box to eliminate blank space
between printing and the end of a tape. Clearing
this check box outputs a tape of the length
specified by Select Tape. Any space between
the printing and the end of the tape is left blank.
•
Check box selected
ABCDE
•
Check box cleared
ABCDE
5
Print Reversed (M) Prints so characters appear normally when
viewed from the back of the tape.
•
Use this setting when printing to fabric
transfer tape (sold separately).
This setting is not necessary when printing
to iron on tape (sold separately).
•
Use this setting when printing to
transparent tape (sold separately) which
will be affixed to the back of glass or some
other transparent surface.
6
Restore Previous
(X)
Restores settings to what they were before
you changed them.