User Manual

2 On the Settings menu, click Figure settings.

3 Conﬁ gure the setting of each item.

4 Click OK.

Adjusting the Size and Angle of a Figure

You can change the size and angle of a ﬁ gure by adjusting the size and

angle of its ﬁ gure ﬁ eld.

For information about how to adjust these properties, see "General Field

Operations" (page 21).

Deleting a Figure Field

1 Click the ﬁ gure ﬁ eld you want to delete.

2 Press the Delete.

This deletes the ﬁ gure ﬁ eld.

■

•

Inserting a Bar Code or Two-

dimensional Code

This section explains how to insert a bar code or two-dimensional code

into a label layout.

Conﬁ rm that the layout screen is displayed.

For information about the layout screen, see "FA-3000 Basic Operations"

(page

8) and "Layout Creation Screen" (page 12).

Click Insert Barcode on the Insert menu, or click the icon.

This displays a menu of supported bar codes and two-dimensional

codes.

2 Select type of code you want to insert.

The bar code types below are supported.

EAN-13(JAN-13), EAN-8(JAN-8), UPC-A, UPC-E, ITF, CODE39,

NW-7(CODABAR), CODE128, GS1-128, GS1 Databar, QR Code,

PDF417, Data Matrix

3 After conﬁ guring the required settings, input the numbers and/or

letters of the bar code.

Depending on the bar code type, you can input control codes and

other digits.

•