User Manual

5 Drag your mouse pointer from the upper left corner down to the

lower right corner of the area you want to capture.

This will surround the area

you dragged across with a

selection boundary.

Guidelines that correspond to the size

of your label layout will also appear on

the screen.

The area you dragged across is inserted into the label layout.

The captured area is inserted as image data.

If you drag across and area that is larger than that shown by the

guidelines, re-size the captured image just as you would re-size a

normal image (page 21).

•

Replacing an Image and

Modifying Image Properties

This section explains how to perform the following image ﬁ eld operations:

replace an image with another one, modify ﬁ eld properties (size and

angle), and delete an image ﬁ eld.

For details about ﬁ elds, see "Using Fields" (page

20).

Replacing the Image in a Field

You can use the procedure below to replace the image in an image ﬁ eld

with a different one.

1 Double-click the image ﬁ eld.

This displays the Insert Image screen.

2 Select the ﬁ le name of the image you want to insert.

3 Click Open.

Adjusting the Size and Angle of an Image

You can change the size and angle of an image by adjusting the size and

angle of its image ﬁ eld.

For information about how to adjust these properties, see "General Field

Operations" (page 21).

Deleting an Image Field

1 Click the image ﬁ eld you want to delete.

2 Press Delete.

This deletes the image ﬁ eld.

•