User Manual

12
5 Confi gure the Label Margins setting.
Margins are the amount of blank space preceding and following
the printing on a label.
Depending on the printer model and print settings, you may not be
able to specify the margin setting.
The amount of tape fed for each margin setting depends on the
printer model.
Printer
Settings
Model
Large Medium Small
KL-G2
Approximately
19mm (
3
/
4
")
Approximately
10mm (
3
/
8
")
Approximately
3mm (
1
/
8
")
CW-L300
Approximately
21.5mm (
7
/
8
")
Approximately
10mm (
3
/
8
")
Approximately
3mm (
1
/
8
")
6 Specify the Tape Direction.
Tape Direction specifi es whether the layout image should be
displayed horizontally or vertically. If you are planning to create a
vertical label, see the label layout hints on page 47.
7 Click OK.
•
•
•
•
Changing the Settings of an Open Label Layout
You can one of the procedures below to change the settings of a
label layout you are editing.
On the Settings menu, click Tape settings and then confi gure
each of the settings.
Change settings using the toolbar (page
18).
•
•
Layout Creation Screen
This section explains the contents of the layout creation screen.
①
Menu bar
⑤
Viewer
⑥
Panel
⑦
Workspace
⑩
Grid
④
Toolbar
②
Panel type box
③
Panel name box
⑨ Layout
size
(within )
⑧
Label size
(within )
①
Menu Bar (page
13)
②
Panel type box
Shows the type of fi elds currently displayed in the panel.
③
Panel name box
Shows the category of fi elds currently displayed in the panel.
④
Toolbar (page
16)