User manual

28
Using a nanoSIM Card
IT-G600/IT-G650 supports nanoSIM cards.
To use WAN functions, a nanoSIM card must be installed.
The nanoSIM card slot is located in the battery pack compartment, so you must remove the
battery pack before installing or removing a nanoSIM card.
Installation
1. Turn the terminal off (shutdown).
2. Remove the battery pack.
(Steps 5 and 6 in the battery pack replacement procedure on page 21)
3 Push in the stylus (opposite end) in direction
and remove the nanoSIM card tray in
direction
.
nanoSIM card slot
Push down with the
stylus until the tray
slides out to the
position indicated
by the “
”.
Push here with the stylus
nanoSIM card tray
4 Install the nanoSIM card in the nanoSIM card tray, as shown in the fi gure.