User manual

27
Attaching the Hand Belt
How to attach the Hand Belt
1. Push the metal hand belt fi tting so that it engages with
the mount on the terminal, as shown in the illustration.
Check that the fi tting is securely attached.
2. Feed the end of the hand belt through the hand belt
mount, fold it back to a suitable length and then fasten
it using the hook and loop fastener.
Precautions for Use
• If you are attaching both the hand belt and the neck strap (or stylus), attach the neck
strap (or stylus) to the strap hole on the barcode reader side of the terminal.
• Continued use with the hand belt pulled very tight could result in the belt being
severed due to friction between the buckle and belt.
• Adjust the hook and loop fastener to a suitable length.
Removing the Hand Belt
1. Press on the projecting part of the terminal and
disengage the metal hand belt fi tting, as shown in the
illustration.
2. Peel apart the hook and loop fastener and pull the
hand belt back through the hand belt mount.