User manual
21
Replacement
1. Turn the screen on.
2. Hold down the Power key until the Power menu is
displayed.
3. Tap “Hot swap” as shown in the fi gure.
4. Tap “OK” as shown in the fi gure and the terminal will
switch to the Hot Swap mode. This causes the
notifi cation LED to light red. Once switching is
completed, the notifi cation LED turns off.
5. Turn the terminal over, turn the left and right battery pack cover lock switches to the
“FREE” position (
) and remove the battery pack cover ( ).
6. Remove the battery pack in the direction indicated by the arrow.
7. Install the replacement battery pack following steps 2 to 3 of the battery pack installation
procedure.
Hotswap