User manual

E-19
Loading
1. Turn the Handheld Terminal over.
Tip!
You can load and remove the battery
pack with the hand belt still attached.
2.
Turn the battery pack cover lock
switches to the “FREE” position and
remove the battery cover.
3. Load the battery pack. Note the battery
polarity (+/ -). T
ake care also to load the
battery pack so that the removal tape
extends above the battery.
4. Fit the bottom edge of the battery pack
cover into the groove in the Handheld
Terminal. (
)
5. Return the battery pack cover to its
original position as shown in the
illustration. (
)
Move the lock switches for the battery
pack cover back to the “LOCK” position.
(
)
When loading the high-capacity battery
pack, be sure to use the high-capacity
battery pack cover.
This precaution also applies when using
the optional fl at battery cover.
Removing
1. Make sure that the Handheld Terminal is turned off.
If the power is on, press the power key to turn it off.
2. Turn the battery pack cover lock
switches on the back of the Handheld
Terminal to the “FREE” position and
remove the battery pack cover.