Specifications

209
Printing Control2 Tab
Marker Detection
This field is used to set up “Begin” or “End” for the Marker Detection.
Figure 3.60
Begin :the marker is detected when it enters the area over the marker sensor
End :the marker is detected when it has passed over the marker sensor(=Default)
The amount of feed can be selected in the range of 0 to 12 mm (0 mm by default).
This is grayed out if “End” is selected.
Error Control
This field is used to set up “System” or “Application” for the Error Control of Splash Cover.
Figure 3.61
System : The Splash Cover Error control by system
Application: The Splash Cover Error control by application(=Default)