Specifications

116
Feed in Forward
It is possible to specify the forward feed with the ESC command “Specify forward feed”. The
forward (positive) feed amount can be set up in the range of 0 to 255 dots or in the range of 0 to
255 mm.
Continuous printing after error
If an error occurs, the printing operation instantly stops. Subsequently, the user can make a
decision as to whether the printing operation is to be continued after canceling the error. To
specify continuous printing after an error use the ESC command.
Character fonts
The following setup parameters can be specified for printing character fonts:
Table 2.85
Parameter Description
Font Possible per character to be
specified.
6x7, 12-dot, 16-dot, 24-dot, OCR-B
Size Possible per character to be
specified.
x1, x1.5, x2, x3, x4
Decoration Possible per character to be
specified.
Bold, reverse, light, smoothing (only for
24-dot mode)
Pitch between
characters
Possible per line to be
specified.
0 to 96 dots. Valid on and after the next line, if
specified in the middle of line.
The standard pitch between characters is for
half-sized characters (Alphabet Numerals and
Katakana (ANK)). For full-sized characters
(Japanese kanji characters), the pitch is double
the standard pitch width value. Note that even
if you change the font size, the pitch width that
has been set will remain unchanged.
Pitch between
lines
Possible per line to be
specified.
0 to 96 dots. Valid on and after the next line, if
specified in the middle of line.
Buffer full
printing
Possible per character to be
specified.
Possible to specify “Enable” or “Disable”.
Mixed character fonts
It is possible to print a mixture of different character fonts, character sizes, character decorations
within one line. The employed line-to-line interval shall be the maximum size (character height)
of the letters contained in that line.