Specifications

114
Bold, Reverse, Light
Reverse in
white/black
Bold and
light
Bold and
reverse
Reverse
and light
Bold, reverse
and light
LightNrmal Bold
Figure 2.16
Printing functions
The following two major printing functions are incorporated into this printer: printing the
character font and printing the bit image.
Print start conditions
The printer will commence its printing job when the print start conditions listed below are met.
• When CR, LF, and FF codes are output (if CR and LF codes are input successively, LF will be
ignored).
• When one line becomes a full.
• When printing of the bit image (including a bit map, screen image, etc.) is attempted.
Paper width
For this printer it is possible to specify the paper width, either 80 mm or 58 mm, to be used
through the Printer Library functions.
Notes:
• It is always necessary to specify the proper paper width for the paper to be used.
• If an attempt is made to print on 80 mm width paper on the printer which has just printed a
58-mm width paper, the printed results may be blurred. For this reason, the user is not
permitted to change the setting to an 80 mm setting after printing on 58 mm paper width.
• If the paper width setting is changed, the setting of the right and left margins will be reset to 0.
The functions of the Printer Library relevant to the “Paper Width” are as follows.
PRNSetPaperWidth
: Sets up paper width.
PRNGetPaperWidth
: Retrieves the current paper width.