User Manual

20060601
2-7
Drawing and Editing Objects
S To draw a polygonTo draw a polygon
1. Perform the following operation: (Draw) – C:Polygon.
2. Move the pointer to the location on the display where you want a vertex of the polygon to
be and then press U.
• Repeat this step as many times as required to specify the other vertices of the polygon. Repeat this step as many times as required to specify the other vertices of the polygon.
3. To complete the polygon, move the pointer to the location of the first vertex and then
press U.
Note
If you press ) in place of step 3, the figure will be finalized as-is, resulting in an unclosed
non-polygon.
S To draw a regular n-gonTo draw a regular n-gon
1. Perform the following operation: (Draw) – D:Regular n-gon.
• This displays a dialog box prompting you to specify the number of sides. This displays a dialog box prompting you to specify the number of sides.
2. Input a value from 3 to 12 and then press U.
3. Perform steps 2 through 4 under “To draw a triangle” (page 2-5).
• This will draw a regular n-gon using the number of sides you specified in step 2. This will draw a regular n-gon using the number of sides you specified in step 2.