User Manual

20060601
2-6
Drawing and Editing Objects
S To draw an isosceles triangleTo draw an isosceles triangle
1. Perform the following operation: (Draw) – 9:Isosc Triangle.
2. Perform steps 2 through 4 under “To draw a triangle” (page 2-5).
• This draws an isosceles triangle. This draws an isosceles triangle.
S To draw a rectangle or a squareTo draw a rectangle or a square
1. Perform either of the following operations: (Draw) – A:Rectangle or (Draw) –
B:Square.
2. Move the pointer to any location on the display and then press U.
• This causes a cross ( This causes a cross () to appear at the pointer location.
3. Move the pointer to another location.
• This causes a selection boundary to appear, indicating the size of the rectangle (or This causes a selection boundary to appear, indicating the size of the rectangle (or
square) that will be drawn.
4. Press U.
• This draws a rectangle or square. This draws a rectangle or square.
• If the location of the pointer when you press If the location of the pointer when you press U is very close to the point you specified
in step 2, the object that is drawn will be the maximum size that fits in the screen.
Note
In the case of a square, each side will be the length of the shorter side of the rectangle you
specify with the selection boundary in step 3.