User guide

112
02
01
02
04
113
05
03
THERMOMETER
The Thermometer measures the current temperature.
You can change the following operation modes by pressing the Right Soft Key
D .
•
Thermometer : The current temperature is displayed in both Fahrenheit and
Celsius.
•
Temperature Comparison : The current temperature is displayed in both
Fahrenheit and Celsius, along with the highest and lowest temperatures from
three selected cities in the city list, which is based on the largest city of each
state.
TIDES
The Tides displays the high and low tide times.
You can change the following operation modes by pressing the Right Soft Key
D .
•
One-Day View : Displays the tidal graph for a single day.
•
Current View : Displays the current tide and the time appropriate for fishing.
SUNRISE SUNSET
The Sunrise Sunset displays the times of sunrise and sunset.
You can change the following operation modes by pressing the Right Soft Key
D .
•
Tracking : Displays the position of the Sun.
•
Day/Night : Displays the ratio between day and night in numeric and graphic
form.
ASTRO CALENDAR
The Astro Calendar displays the moon’s phase and date in the lunar cycle, and days until
full moon and new moon.
You can change the following operation modes by pressing the Right Soft Key D.
• Lunar Phase : Displays the phase of the Moon.
•
Cosmic View : Displays the location of Sun, Moon, and Earth.
STAR GAZER
The Star Gazer displays the stars in the sky and the names of the constellations and
major stars.
USING G’ZGEAR® WITH THE FLIP CLOSED
You can use the G’zGEAR function when the handset’s flip is closed.
1. Press the Center Select Key [ MENU ], select Settings&Tools , then press the
Center Select Key [OK] .
2. Select
Tools and press the Center Select Key [OK] , and select G’zGEAR then
press the
Center Select Key [OK] .
3. Close the flip.
SETUP
You can set the G’zGEAR® settings by selecting one of the following options:
1. Press the Center Select Key [ MENU ], select Settings&Tools , then press the
Center Select Key [ OK ].
2. Select
Tools and press the Center Select Key [ OK ], and select G’zGEAR then
press the
Center Select Key [ OK ].
3. Select
Setup and press the Center Select Key [ OK ].
•
G_SWITCH : Enables switching of tools by shaking the handset to the left with
the flip open.
•
Save Last Mode : Displays the previously displayed mode when starting a tool.
•
Backlight : Keeps the displayed backlight on while G’zGEAR® is active.
•
Pedometer : Counts your steps with pedometer.
•
Calibration : Calibrates the electronic compass.
•
Restore Defaults : Returns G’zGEAR® settings to initial value.
• When you open/close the flip, you must calibrate the compass. Otherwise, it may
malfunction.