User manual

Compass (Bearing Measurement)
For serious mountain climbing and other activities that require accurate
bearing readings, take along a highly reliable compass to use in combination
with the watch’s compass.
Important!
●
Note that accurate compass readings and/or correction will not be
possible in the areas described below.
ー
In the vicinity of a permanent magnet (magnetic accessory, etc.),
metal objects, high-voltage wires, aerial wires, or electrical household
appliances (TV, computer, cellphone, etc.)
ー
On trains, on boats, on aircraft, etc.
ー
Indoors, especially inside of reinforced concrete structures.
Altimeter, Barometer
The watch’s Altimeter uses a pressure sensor to measure barometric
pressure, and then calculates and displays relative altitude based on the
measured value. Because of this, readings taken at different times at the
same location may produce different altitude values due to changes in
temperature, humidity, barometric pressure, and other factors. Also note that
values displayed by the watch may be different from elevations indicated for
areas where you are located. When using the watch’s altimeter while
mountain climbing, it is recommended that you perform regular correction in
accordance with the local altitude (elevation) indications.
Tide Graph (Graphic Display of Tide Information)
The Tide Graph feature of your watch is intended to provide a rough image
of current tide conditions. Do not use its tide information for navigation
purposes. For navigation purposes, be sure to use official tide charts issued
by a reliable agency or authority for the area you are navigating. Displayed
tide levels are approximations intended for reference only. Geographic
features and weather in your current location may cause errors in readings.
EN-112