User manual

GPS Function Precautions
●
Whenever you are in any area where radio wave reception is prohibited or
restricted, perform the operation below to turn off the “Location” setting.
1. While a watch face is displayed, swipe the touch screen from top to
bottom and then tap D.
2. Scroll downwards and tap “Connectivity” and then “Location”.
3. On the screen that appears, disable “Location”.
●
Map data may include information that is incorrect. Also, all countries and
geographic areas may not be provided in the map data.
●
Some location and address names may not display correctly due to
applicable laws and restrictions in certain countries and geographic areas.
●
The location information provided by the GPS function of this watch is
intended for reference purposes only and locations shown may not be
accessible or difficult to access. Also, map information may show
mountains, jungles, deserts, and other dangerous or lawless locations.
Before going to an unknown location, be sure to check on the latest
information available about laws and safety.
●
Using this watch in the vicinity of a mobile phone or other device that uses
1.5 GHz band radio waves may make signal reception impossible.
●
Depending on reception conditions, GPS positioning information may
include error up to several hundred meters.
●
Location information is not acquired while flying on an aircraft or otherwise
moving at very high speed.
●
Never use the GPS function of this watch for surveying or any other
measuring that requires high accuracy.
●
Never use the GPS function of this watch for navigation of boats, aircraft,
motor vehicles, individuals, etc.
●
Location measurements are performed using satellites that are operated
and managed by the United States (GPS), Russia (GLONASS), and Japan
(QZSS). Because of this, there is always the possibility that access to its
information may be disabled at the discretion of these countries.
EN-111