Operation Manual

20050401

12-1-1

Connecting Two Units

12-1 Connecting Two Units

The following procedure describes how to connect two units with the connecting cable that

comes equipped as a standard accessory.

u To connect two units

1. Check to make sure that the power of both units is off.

2. Remove the covers from the connectors of the two units.

3. Connect the two units using the cable.

4. Perform the following steps on both units to specify 3PIN as the cable type.

(1) From the Main Menu, enter the LINK mode.

(2) Press 4(CABL). This displays the cable type selection screen.

(3) Press 2(3PIN).

Cable

# Models that are supported for this configura-

tion are shown below.

fx-9860G SD

fx-9860G

# Be sure you keep the connector covers in a safe

place so you can replace them after you finish

your data communications.

# Keep the connectors covered when you are not

using them.