User Manual

ε-45

Graph Analysis Tool Graph Screen Operations

6. Input a value in the range of 1 to 10, and then press w.

• The graph relation list appears with the calculation

result.

7. Pressing 6(DRAW) here graphs the function.

• This lets you compare the expanded function graph

and the original graph to see if they are the same.

Note

• When you press 6(DRAW) in step 7, the graph of the result of the Fourier series

expansion may not align correctly with the original graph on which it is overlaid. If this

happens, shift the position the original graph to align it with the overlaid graph.

For information about how to move the original graph, see “To move a particular graph on

a multi-graph display” (page

ε-48).

k Performing Regression

You can use the procedure below to perform regression for a range specified using the trace

pointer. All of the following regression types are supported: Linear, Med-Med, Quadratic,

Cubic, Quartic, Logarithmic, Exponential, Power, Sine, and Logistic.

For details about these regression types, see Chapter 6 of this manual.

The following procedure shows how to perform quadratic regression. The same general

steps can also be used to perform the other types of regression.

• To perform quadratic regression

1. On the graph screen, press K, and then 4(CALC).

• The CALC menu appears at the bottom of the display.

2. Press 5(X

• This displays the trace pointer for selecting the range

on the graph.

3. Move the trace pointer to the start point of the range for which you want to perform

quadratic regression, and then press w.