User Manual

α-12
• Picture Plot mode errors
When you see
this message:
It means this: So you need to do this:
Too many
plots
In the Picture Plot mode, the number
of plots exceeds the allowable upper
limit.
—
• Setup errors
When you see
this message:
It means this: So you need to do this:
Out of Domain Attempting to input a value that is
outside the allowable input range.
Input a value that is within the
allowable range.
Invalid setting • Input of an improper V-Window value.
• Input of an improper value on the
range screen and use of that value for
execution.
• Attempting to create a table with a
Step value of 0.
• Attempting to input illegal V-Window
setting combinations.
Example: Xmin = 10, Xmax = 10
• Attempting to create a table in the
Recursion mode when the Start
value is greater than or equal to the
End value.
• The Edit Animations screen is
configured with the setting t0=t1 in
the Geometry mode.
• Internal calculation generated a
mathematical error (division by zero,
etc.) when executing a function
calculation, or a calculation in the
Financial mode or Statistics mode.
•
Improper values were input in the
3D Graph mode for a template
coefficient.
• Change the V-Window value so it is
within range.
• Input a proper range value.
• Specify a Step value other than 0.
• Enter values that have the proper
relationship with each other.
• Change the value so the Start value
is less than the End value.
• Configure the Edit Animations
screen so t0 and t1 are assigned
different values for the same
animation.
• Since the calculation contains one
or more values that cannot be
calculated, input different values
and try again.
• Input coefficient values that can
define the 3D graph.
Out of Range Calculation result that exceeds the
calculator display range.
Change the calculation formula.