User Manual

β-3

u Exiting the Examination Mode

There are three ways to exit the Examination Mode.

(1) Exiting the Examination Mode by Connecting to a Computer

1. Use the USB cable to connect the calculator that is in the Examination Mode to a

computer.

2. When the “Select Connection Mode” dialog box appears on the calculator, press the

calculator’s 1 key.

3. On the computer, open the calculator drive.

4. On the computer, copy or delete any file that is on the calculator drive.

5. Terminate the connection between the calculator and computer.

• The dialog box shown below will appear when you exit the Examination Mode.

(2) Exiting the Examination Mode by Allowing 12 Hours to Elapse

Approximately 12 hours after entering the Examination Mode, turning on the calculator will

cause it to exit the Examination Mode automatically.

Important!

If you press the RESTART button or if you replace batteries before turning on the

calculator, it will re-enter the Examination Mode when turned on, even if 12 hours have

elapsed.

(3) Exiting the Examination Mode by Connecting to another Calculator

1. On the calculator that is in the Examination Mode (Calculator A), enter the Link mode

and then press 4(CABLE)2(3PIN).

2. Use the optionally available SB-62 cable*

to connect Calculator A to another calculator

that is not in the Examination Mode (Calculator B).

Included with the calculator in some areas.

SB-62 cable