User manual - fx-9860G Manager PLUS

– 46 –
メッセージ 意 味 対処方法
The image could not be sent
from the calculator.
(1) Try pressing a key on the
calculator.
(2) Check to make sure that
the calculator is in the OHP
Mode.
If the screen is not sent after
you perform the above steps,
disconnect the USB cable and
check the calculator setup.
Next, reconnect and try again.
For details, select the following
on the menu bar: Help -
Manual - Manager PLUS, or
refer to the Manager PLUS
user’s guide.
電卓の画面を受信できない。 画面に出ている対処方法をお
試しください。
詳しくは“10. Screen
Receiver (電卓の画面をパソ
コンに表示する)”を参照してく
ださい。
The connection has been
broken for some reason and is
being restored.
If data communication does
not resume after some
time, perform the operation
described below.
Try pressing a key on the
calculator. If the screen is
not sent after you perform
the above steps, disconnect
the USB cable and check
the calculator setup. Next,
reconnect and try again.
For details, select the following
on the menu bar: Help -
Manual - Manager PLUS, or
refer to the Manager PLUS
user’s guide.
−
画面に出ている対処方法をお
試しください。