User Manual

1-30
u Show Cell (spreadsheet cell display mode)
• { Form } / { Val } ... {formula}*
1
/{value}
u Move (spreadsheet cell cursor direction) *
2
• { Low } / { Right } ... {move down}/{move right}
*
1
Selecting “Form” (formula) causes a formula in the cell to be displayed as a formula. The
“Form” does not affect any non-formula data in the cell.
*
2
Specifies the direction the cell cursor moves when you press the w key to register cell
input, when the Sequence command generates a number table, and when you recall data
from List memory.
9. Using Screen Capture
Any time while operating the calculator, you can capture an image of the current screen and
save it in capture memory.
u To capture a screen image
1. Operate the calculator and display the screen you want to capture.
2. Press !h(CAPTURE).
• This displays a memory area selection dialog box.
3. Input a value from 1 to 20 and then press w.
• This will capture the screen image and save it in capture memory area named “Capt
n ”
( n = the value you input).
• You cannot capture the screen image of a message indicating that an operation or data
communication is in progress.
• A memory error will occur if there is not enough room in main memory to store the screen
capture.
u To recall a screen image from capture memory
This operation is possible only while the Linear input/output mode is selected.
1. In the RUN • MAT (or RUN ) mode, press K6( g)
6( g) 5(CAPT)( 4(CAPT) on the fx-7400G
II )
1(RCL).
2. Enter a capture memory number in the range of 1 to 20, and then press w.
• This displays the image stored in the capture memory you specified.