User Manual

13-1

Chapter 13 Data Communications

This chapter tells you everything you need to know to transfer programs between two CASIO

Power Graphic calculators connected using the optionally available SB-62 cable*.

* Included with the calculator in some areas.

1. Connecting Two Units

The following procedure describes how to connect two units with the SB-62 cable.

u To connect two units

1. Check to make sure that the power of both units is off.

2. Connect the two units using the SB-62 cable.

• Step 3 is not required on the fx-7400G II .

3. Perform the following steps on both units to specify 3PIN as the cable type.

(1) From the Main Menu, enter the LINK mode.

(2) Press 4(CABL). This displays the cable type selection screen.

(3) Press 2(3PIN).

SB-62 cable

• Models that are supported for this configuration are shown below.

fx-9860G

II SD, fx-9860GII, fx-9860GII s, fx-9860G AU PLUS, fx-9750GII, fx-7400GII,

fx-9860G Slim (OS 1.11), fx-9860G SD (OS 2.0/1.05), fx-9860G (OS 2.0/1.05), fx-9860G AU

(OS 2.0/1.05), fx-7400G series, CFX-9850G series

Connecting the Calculator to a Personal Computer

You can transfer data between the calculator and a computer by using the Program-Link

Software (FA-124) and a special cable*

to establish a connection between them.

For details about establishing a connection and data transfer procedures, see the FA-124

User’s Guide.

With the fx-9860GII SD, fx-9860GII, fx-9860GII s, and fx-9860G AU PLUS, use the

Program-Link Software and the optionally available USB cable*.

For the fx-9750GII and fx-7400GII, you will need to purchase the FA-124.

* Included with the calculator in some areas.