User Manual

4. On the computer, click the toolbar button.

• The dialog box shown below will appear when you exit the Examination Mode.

• The FA-124 software will display an error message at this time, but just ignore it.

(2) Exiting the Examination Mode by Allowing 12 Hours to Elapse

Approximately 12 hours after entering the Examination Mode, turning on the calculator will

cause it to exit the Examination Mode automatically.

Important!

If you press the RESTART button or if you replace batteries before turning on the

calculator, it will re-enter the Examination Mode when turned on, even if 12 hours have

elapsed.

(3) Exiting the Examination Mode by Connecting to another Calculator

1. On the calculator that is in the Examination Mode (Calculator A), enter the LINK mode

and then press 4(CABL)2(3PIN).

2. Use the SB-62 cable to connect Calculator A to another calculator that is not in the

Examination Mode (Calculator B).

3. On Calculator A, press 2(RECV).

4. On Calculator B*, enter the LINK mode and then press 3(EXAM)1(UNLK)1(Yes).

• You could also transfer any data from Calculator B to Calculator A.

Example: To transfer setup data to Calculator A

1. On Calculator B, enter the LINK mode and then press 1(TRAN)1(MAIN)1(SEL).

2. Use c and f to select “SETUP”.

3. Press 1(SEL)6(TRAN)1(Yes).

* Calculator with Examination Mode function

• The

icon will disappear from the display when the calculator exits the Examination Mode.

u Displaying Examination Mode Help

You can display Examination Mode help in the LINK mode.

3(EXAM)2(ENTR) ... Displays help about entering the Examination Mode.

3(EXAM)3(APP) ... Displays help about what modes and functions are disabled in

the Examination Mode.

3(EXAM)4(EXIT) ... Displays help about exiting the Examination Mode.