User Manual

k Converting a CFX-9850 Series Program to a fx-9860 Series Compatible

Program

To use an EA-200 control program created on the CFX-9850 Series calculator (for use on

the CFX-9850) on the E-CON3, you need to convert the program to an fx-9860 program.

Conversion can be performed using the program converter.

EA-200 Control Program for

CFX-9850 Series

EA-200 Control Program for

fx-9860 Series

Convert

To convert a program

1. Transfer the EA-200 control program created for the CFX-9850 Series to the fx-9860

main memory.

• Use the cable that comes bundled with the fx-9860 to connect its 3-pin serial port to the

3-pin serial port of the CFX-9850. For details, see “Chapter 13 Data Communication”.

2. Perform step 1 under “To convert a setup to a program” on page 7-1, which displays the

program converter screen.

3. Press 1(CALC) and then press 4( → 38K).

• This displays a list of programs currently in main memory.

4. Use f and c to move the highlighting of the program you want to convert, and then

press 1(EXE) or w.

• A program name input screen will appear after conversion is complete.

5. Enter up to eight characters for the program name.

• If you want to password protect the program, perform steps 6 and 7 under “To convert a

setup to a program” after inputting the program name.

6. Press w to start conversion of the program.

• The message “Complete!” appears when conversion is complete. To clear the message,

press w or J.

7-4

Using Program Converter