User Manual

5 Using the MULTIMETER Mode

You can use the Channel Setup screen (page 3-3) to configure a channel so that Data

Logger MULTIMETER Mode sampling is triggered by a calculator operation.

To use the MULTIMETER Mode

1. Connect the calculator and Data Logger, and connect the sensors you want to the

applicable Data Logger channels.

2. From the Advanced Setup menu (page 3-1), use the Channel Setup screen (page 3-3) to

configure sensor setups for each channel you will be using.

3. After configuring the sensor setups, press w to return to the Advanced Setup menu

(page 3-1), and then press 2(MLTI).

• This starts sampling in the Data Logger MULTIMETER mode and displays a list of

sample values for each channel.

• Displayed sample data is refreshed at 0.5-second intervals.

• Do not connect sensors to any other channels except for those you specified in step 2.

• Data sampled in the MULTIMETER mode is not saved in memory.

4. To end MULTIMETER mode sampling, press the w key.

5-1

Using the MULTIMETER Mode