User Guide

Specifications
Accuracy at normal temperature: ±20 seconds a month
Stopwatch: Measuring Capacity: 9'59" (10 minutes)
Measuring Unit: 1 second
Measurements: Elapsed time; split time; two finishes
Battery: One silver oxide battery (Type: SR920SW)
Battery Life: Approximately 3 years
Specifications are subject to change without notice.
Perform the following procedure if the stopwatch hands do not return to their 0 (zero)
positions when you reset the stopwatch.
Correcting the 0 Positions of the Hands
Pull the Crown out to Click 2.
Use A (clockwise) and B (counterclockwise) to move the
Stopwatch Second Hand
to 12 o’clock and the
Stopwatch Minute Hand
to 0.
• Holding down either button will move the second hand at high speed, until you
release the button.
• The
Stopwatch Minute Hand
is synchronized with the
Stopwatch Second Hand
.
After all of the hands are the way you want, push the Crown back in.
Important!
• Timekeeping stops while the crown is pulled out. Correct the current time setting
after performing the above operation.
Using the Stopwatch
Important!
• Do not operate the stopwatch with the crown pulled out.
Note
• An elapsed time operation will stop automatically at the end of 10 minutes.
The stopwatch measures elapsed time in 1-second increments up to 9minutes,
59seconds.
Elapsed time
A
A A A B
Start Stop Resume Stop Reset
Split time
A
B B A B
Start Split Split release Stop Reset
Two finishes
A
B A B B
Start Split
First runner
finishes.
Display time of
first runner.
Stop
Second runner
finishes.
Split release
Display time of
second runner.
Reset