Owner's Manual

44
Configuring Printing Properties
Use the Printer, Layout, and Format tabs to configure printing properties.
To configure printing properties
1
Click the Printer tab.
2
Configure the settings described below.
• Some Label Printer models do not support variable margin settings.
• The actual amount of tape that is fed with each margin setting depends on the
Label Printer model you are using, as shown in the table below.
• All values in the above tables are approximate.
• Normally, you should leave the Print Density set to 3. Change this setting only
when printed characters are broken or too dark.
• With the KL-E20/KL-P1000 Label Printer, margins (small) are inserted only during
continuous printing, without tape cutting. If you want to have margins inserted,
configure the FA-B30 Software as described below.
•
Print without tape cutting.
On the Display tab, clear the Stop between prints for tape cut. check box.
•
Do not use a fixed tape length.
On the Layout tab, clear the Fix Tape Length check box.
Model
Large Medium Small
KL-E20/KL-P1000 Approx. 16 mm – Approx. 3 mm
EL-5000W
(EZ-LABEL Approx. 18.8 mm Approx. 10 mm Approx. 3 mm
PRINTER Tape)
EL-700 Approx. 19.3 mm Approx. 10 mm Approx. 3 mm
CW-L300 Approx. 21.5 mm Approx. 10 mm Approx. 3 mm
Margins
FAB30_Ver1.02_E_p40-56.p65 04.11.22, 11:44 AM44