User Manual

21
. Camera Limitations
Depending on the model of the camera being used there may be limitations on
shooting. Equipped functions depend on the camera model.
• The Movie Quality is always STD (640
x
480) when shooting with Remote Capture.
•“O Tracking” cannot be selected for the AF area setting while shooting with
Remote Capture. If “O Tracking” is selected in another mode, selecting Remote
Capture will cause the AF area setting to change to “U Spot”.
• The Motion Shutter cannot be used while shooting with this function.
• Some camera models let you change to another recording mode. Available
recording modes depend on the camera model.
• Depending on your camera model, the settings below can be configured with
EXILIM Connect while Program Auto High Speed CS is selected as the recording
mode. The settings you can configure depend on your camera model.
High Speed CS fps, Maximum CS Shots, Pre-record CS Shots, Pre-record CS
• When the focus mode setting is “AF” (Auto Focus) or “Macro”, continuous AF is
enabled during Remote Capture and focus is performed in the center of image.
• Certain camera models allow interval recording of snapshots (Interval Snapshot).
To start an Interval Snapshot operation, select either of the modes below as the
EXILIM Connect recording mode. The recording mode you can select depends on
your camera model and camera setup.
Interval Shot ( Standard, Intelligent), Stationary Shot*
* When the camera is paired with a smartphone, these modes cause images to be
sent to the smartphone automatically as they are shot by the camera. Note,
however, that the shooting interval is fixed. Also, there are some limitations on
camera operation.