User Manual

15
Editing Images
When the playback timing of the two movies that make up a Full 360° movie are out
of sync, you can use the procedure below to adjust it. During playback of a Full 360°
Movie, the audio of only one of the movies is played back. You can specify which of
the movie’s audio should play back.
1. On the editing screen, click .
2. Use the adjustment buttons ( and ) to adjust the playback
timing of the movies.
Use the procedure below to trim the beginning and end of a movie. In the case of a
Full 360° movie, both of the movies are cut.
1. On the editing screen, click .
2. You can change the trim locations by dragging the handles of the
controller area seek bar left or right.
Adjusting the Playback Timing of a Movies
Trimming the Beginning and End of a Movie
Handles