User`s guide

Table Of Contents

BASIC IMAGE RECORDING

In the REC mode, press [MENU].

Use [왗] and [왘] to select the “Quality” tab.

Use [왖] and [왔] to select “Flash Assist”, and

then press [왘].

Flash assist used Flash assist not used

Using Flash Assist

Recording a subject that is outside the flash range can

cause the subject to appear dark in the resulting image,

because not enough of the flash reaches the subject. When

this happens, you can use flash assist to correct the

brightness of the recorded subject, so it appears as if the

flash illumination was sufficient.

Changing the Flash Intensity Setting

Perform the following steps to change the flash intensity

setting.

In the REC mode, press [MENU].

Use [왗] and [왘] to select the “Quality” tab.

Use [왖] and [왔] to select “Flash Intensity”,

and then press [왘].

Use [왖] and [왔] to select the setting you

want, and then press [SET].

IMPORTANT!

• Flash intensity may not change if the subject is too

far or too close to the camera.

To make flash intensity:

Stronger

Normal

Weaker

Select this setting:

–1

–2