User manual

2007.

All

Rights

Reserved by ATP Electronics Taiwan Inc.

Inserting Batteries

1. The following batteries are acceptable.

 LR03 (size AAA) alkaline battery x 2

 R03 (size AAA) Nickel-Metal Hydride battery x 2

2. Carefully slide down the rear battery cover and insert 2 AAA batteries into the device in the orientation

displayed inside.

3. Replace the battery cover.

4. Power ON the device and the LED will flash Green for 2~3 seconds.

5. After usage, be sure to first turn OFF the power before removing the battery. (Based on 1000mA)

LR03 (size AAA) alkaline battery R03 (size AAA) Nickel-Metal Hydride battery

About 8 hours About 7.5 hours

WARNING

There is a danger of leakage or explosion if batteries are mishandled. Please be sure to observe

the following:

 Insert batteries with the correct polarity +/-.

 Do not attempt to charge a dry battery.

 Remove the batteries when not using the device for a prolonged period of time.

 Do not break disrupt or switch off power when the device is transferring data to a memory card.