User manual
Table Of Contents
- Unpacking
- Read this first!
- Contents
- General Guide
- Monitor Screen Contents
- Quick Start Basics
- What you can do with your CASIO camera
- Changing the Camera Style to Suit Shooting Conditions
- Using the Touch Panel
- First, charge the battery prior to use.
- Configuring Basic Settings the First Time You Turn On the Camera
- Preparing a Memory Card
- Turning Power On and Off
- To Shoot a Snapshot
- Viewing Snapshots
- Deleting Snapshots and Movies
- Snapshot Shooting Precautions
- Recording Images
- Using BEST SHOT
- Advanced Recording Settings
- Using the REC Menu
- Using Touch Shutter (Touch Shutter)
- Using the Self-timer (Self-timer)
- Using the LED Light (LED)
- Changing the Image Size (Image Size)
- Movie Image Quality Settings (Movie Quality)
- Correcting Image Brightness (EV Shift)
- Adjusting White Balance (White Balance)
- Specifying ISO Sensitivity (ISO)
- Selecting a Focus Mode (Focus)
- Turning on Image Review (Review)
- Using the REC Menu
- Viewing Snapshots and Movies
- Other Playback Functions (PLAY)
- Printing
- Using the Camera with a Computer
- Other Settings (Set Up)
- Adjusting Monitor Screen Brightness (Screen)
- Turning off Eye-Fi Card Communication (Eye-Fi)
- Configuring Camera Sound Settings (Sounds)
- Time Stamping Snapshots (Timestamp)
- Configuring World Time Settings (World Time)
- Setting the Camera’s Clock (Adjust)
- Specifying the Date Style (Date Style)
- Specifying the Display Language (Language)
- Calibrating the Touch Panel (Calibrate TP)
- Selecting the HDMI Terminal Output Method (HDMI)
- Formatting Built-in Memory or a Memory Card (Format)
- Resetting the Camera to Factory Defaults (Reset)
- Configuring Monitor Screen Settings
- Appendix
22
Quick Start Basics
Back Lamp Operation
5. After charging is complete, disconnect the USB cable from the camera
and then from the computer.
NOTE
• Even if you turn off the camera, the battery will continue to charge if there is a USB
connection with a computer. Under this condition, the back lamp operates as
described under “Back Lamp Operation” (page 19).
IMPORTANT!
• Charging is not performed while the connected computer is in the hibernate mode.
• A charging error can occur immediately after charging begins or some time after
charging begins. A charging error is indicated by the back lamp flashing red.
• If low supply capacity exists due to your computer model or connection conditions,
charging will start without the camera turning on. Turning on the camera in this
case will cause charging to stop and enter USB data communication between the
camera and the computer. The camera's back lamp will be lit green at this time.
Other Charging Precautions
• A battery that is still warm due to normal use may not charge fully. Leave the
camera turned off and wait for a while to give the battery time to cool before
charging it.
• A battery discharges slightly. Because of this, it is recommended that you charge
the battery immediately before you need to use it.
• Charging the battery may cause interference with TV and radio reception. If this
happens, plug the USB-AC adaptor into an outlet that is further away from the TV
or radio.
• Actual charging time depends on the current battery level and charging conditions.
• Do not use the USB-AC adaptor with any other device.
Lamp Status Description
Lit Amber Charging
Lit Red
Charging in progress (Data transfer with
computer not supported.)
Flashing Red
Abnormal ambient temperature, or
battery problem (page 109), or charging
terminated by the timer
Lit Green Charging complete, or charging stopped
Back lamp