User`s guide
Table Of Contents
- INTRODUCTION
- QUICK START GUIDE
- GETTING READY
- BASIC IMAGE RECORDING
- OTHER RECORDING FUNCTIONS
- Selecting the Focus Mode
- Exposure Compensation (EV Shift)
- Using the Built-in ND Filter
- Adjusting White Balance
- Specifying the Exposure Mode
- Using the BEST SHOT Mode
- Recording a Movie
- Instant Movie Setups (MOVIE BEST SHOT Mode)
- Recording Audio
- Using the Histogram
- REC Mode Camera Settings
- Specifying ISO Sensitivity
- Selecting the Metering Mode
- Using the Filter Function
- Specifying Outline Sharpness
- Specifying Color Saturation
- Specifying Contrast
- Turning the On-screen Grid On and Off
- Turning Image Review On and Off
- Using Icon Help
- Assigning Functions to the [<] and [>] Keys
- Specifying Power On Default Settings
- Resetting the Camera
- Using the Shortcut Menu (EX Menu)
- Installing the Lens Hood and a Lens Filter
- PLAYBACK
- DELETING FILES
- FILE MANAGEMENT
- OTHER SETTINGS
- USING A MEMORY CARD
- PRINTING IMAGES
- VIEWING IMAGES ON A COMPUTER
- USING THE CAMERA WITH A COMPUTER
- APPENDIX
BASIC IMAGE RECORDING
69
[
]
Using the Flash
Perform the following steps to select the flash mode you
want to use.
• The approximate effective range of the flash is shown
below.
Approximately 0.4 to 3.0 meters (1.3´ to 9.8´)
(ISO Sensitivity: Auto)
* Depends on zoom factor.
1.
In a REC mode, press [ ].
• Each press of [ ] cycles through the flash mode
settings described below on the monitor screen.
To do this:
Have the flash fire automatically when
required (Auto Flash)*
Turn off the flash (Flash Off)
Always fire the flash (Flash On)
Fire a pre-flash followed by image
recording with flash, reducing the
chance of red-eye in the image (Red-
eye reduction)
In this case, the flash fires automatically
when required
Select this setting:
None
* When using Icon Help (page 124), select “ Auto
Flash”.
Flash mode indicator
C