User manual - EXFS10_M10_FB

47
Snapshot Tutorial
Pressing Ç (Continuous Shutter) toggles between the
Continuous Shutter mode and the Single Shot mode
(page 24).
With normal-speed continuous shutter (Normal Speed CS) you can shoot a series of
images at a speed of approximately one image per second as long as there is
memory available for image storage.
1. In the REC mode, press [MENU].
2. Use [4] and [6] to select the “REC” tab.
3. Use [8] and [2] to select “CS” and then press [6].
4. Use [8] and [2] to select “Normal Speed CS”, and then press [SET].
5. Press Ç (Continuous Shutter).
• This will display Z (Normal Speed CS) and
surround the monitor screen with a yellow frame.
If this does not happen, press
Ç again.
6. Hold down the shutter button to shoot.
Images continue to be shot as long as you keep the
shutter button depressed and there is memory
available to store them. Releasing the shutter button
stops shooting.
IMPORTANT!
• Combining Normal Speed CS images into a CS group (page 95) manually on the
playback screen is not supported.
• You cannot specify the number of images shot per second (fps) with Normal Speed
CS.
• The number of images per second (fps) of Normal Speed CS varies slightly
depending on the type of memory card you are using and its current condition
(remaining capacity, fragmentation state, etc.)
• You cannot use Normal Speed CS in combination with Prerecord CS.
Using Continuous Shutter
Using Normal-speed Continuous Shutter
Ç (Continuous Shutter)
Normal Speed CS icon
Yellow frame