User`s guide

65
SHOOTING A SNAPSHOT
NOT
E
• The aperture value indicates the size of the opening that
lets light into the camera. A larger aperture value indicates
a smaller opening. The camera adjusts this setting
automatically.
• Shutter speed indicates the amount of time that light is
allowed into the camera. A slower shutter speed means
that light is allowed in for a longer time. Shutter speed is
indicated on the monitor screen as seconds (1/1000
second, etc.) The camera adjusts this setting automatically.
If the image does not focus...
If the focus frame stays red and the operation lamp is flashing
green, it means that the image is not in focus (because the
subject is too close, etc.). Point the camera at the subject and try
to focus again.
Checking a Snapshot
A snapshot will remain on the monitor screen for a short while
after you shoot it and then disappear when the camera gets
ready for the next image.
Perform the following operation to view a snapshot after you
shoot it.
Press [ ].
This will display the snapshot you just shot.
Use [W] and [X] to scroll through other images in memory.
To return to the REC mode, press [ ].