User manual

●
Stopwatch Mode
The second hand, and the small hour and
minute hands indicate the elapsed stopwatch
time.
●
The main hour and minute hands indicate
the current time.
30
①②③
④⑤
Start/Stop
Reset/Flyback
A Stopwatch hours
B Stopwatch minutes
C Stopwatch seconds
D Stopwatch hours (24-hour time)
The hand points to the A-side for hours 0
through 11, and to the P-side for hours 12
through 23.
E Target time indicator
Shows the difference between the current
and previous lap times.
●
Alarm
The small hour and minute hands indicate the
alarm time.
The second hand indicates the alarm enabled/
disabled setting.
●
The main hour and minute hands indicate
the current time.
30
Enabling/
Disabling the
Alarm
①
②
④
③
A Alarm enabled/disabled
B Alarm minute
C Alarm hour
D Alarm hour (24-hour time)
The hand points to the A-side for a.m.
times, and to the P-side for p.m. times.
Using the Crown
●
Fast Forward/Fast Reverse
Second click
First click
Normal timekeeping
Crown
Important!
●
To prevent loss of water resistance
and/or damage due to impact, be sure
to push the crown in to its normal
position after you are finished using it.
●
When pushing the crown back in, take
care not to apply too much force.
After pulling out the crown to the first or second
click, rotating it quickly in succession in either
direction will start a fast forward or fast reverse
operation. While a fast forward operation is in
progress, quickly rotating the crown in
succession again will increase the speed even
further.
●
Stopping Fast Forward/Fast Reverse
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Hand and Day Indicator
Movement
30
Function hand
Day indicator
●
Function Hand and Day Indicator
Movement
Changing the day setting of the watch will also
cause the function hand to move.
●
Day
●
It can take anywhere from about 50 seconds
to about 3 minutes and 20 seconds for the
day indicator to change after timekeeping
reaches midnight. At this time, the function
hand moves as the day indicator changes.
●
The day may not be indicated correctly
while the watch’s crown is pulled out.
Operation Guide 5639
3