User manual

Checking the Difference
Between the Current and
Previous Lap Times
You can check the difference between the
previous and current lap times while a lap time
measurement operation is in progress.
Using Auto Adjust
Pressing (B) displays the difference between
the current and previous lap times.
A
B
B
B
A
Timing Start 2
Timing Start 1
Stop
Timing Start 3
Timing Start 4
Lap Time 1
Lap Time 2
Lap Time 3
●
When you measure a lap time, the function
hand indicates the difference between the
current and previous lap times.
●
From measurement of the second lap time,
you can check the difference between the
current and previous lap times.
To determine the difference between the
current and previous lap times
Same as previous lap time
1 second
slow
2+ seconds
slow
1 second
fast
5 seconds
fast
5+ seconds
fast
Target time indicator
Other Settings
This section explains other watch settings you
can configure.
Configuring Dual Time
Settings
Dual Time lets you keep track of the current
time in another time zone in addition your
current location time.
1. Pull out the crown to the first click.
This causes the second hand to move to
12 o’clock, and the function hand to move
to [DT].
30
Crown
Function hand
2. Rotate the crown to change the Dual Time
setting.
●
You can set the Dual Time in 15-minute
increments.
30
＋
−
Dual Time 24-hour
Dual Time hour and minute
3. Push the crown back in.
Configuring Alarm Settings
The watch will beep when the alarm time is
reached.
●
The beeper is muted in the cases described
below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l
Power Saving
1. Pull out the crown to the first click.
This causes the second hand to move to
12 o’clock, and the function hand to move
to [DT].
30
Crown
Function hand
2. Press (A).
This causes the function hand to move to
[ALM] and turns on the alarm.
3. Rotate the crown to change the alarm time
setting.
●
Check the 24-hour hand to see if it is
indicating a.m. or p.m. for the alarm
time.
30
＋
−
Alarm on
Minutes
Hours
Crown
4. Push the crown back in.
●
To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
●
A beeper sounds for 10 seconds when
an alarm time is reached.
●
You can also use EDIFICE Connected
to configure alarm time settings.
Operation Guide 5639
13