User manual - Chapter 3: Commands and Programming

Chapter 3: Commands and Programming

Example Program

The following is an example program written for the CFX-9850G.

Cls ↵

{1,0} → List 6 ↵

Send(List 6) ↵

{1,1,1} → List 6 ↵

Send(List 6) ↵

{3,0.5,100,1} → List 6 ↵

Send(List 6) ^

Receive(List 1) ↵

Receive(List 2) ↵

S-Gph1 DrawOn,Scatter,

List1,List2,1,Dot,

Blue ↵

S-Gph2 DrawOff ↵

S-Gph3 DrawOff ↵

DrawStat

Sending Commands from a

Calculator to the Data Analyzer

This section explains how to send individual command from a graphic scien-

tific calculator to the data analyzer. Note that the procedure you should use

depends on whether you are using a CFX-9850G or a CFX-9800G calcula-

tor.

Sending List Data with the CFX-9850G “Send(”

Command

Use the CFX-9850G calculator’s Send(List) command to send list data to the

data analyzer, which executes commands in accordance with the contents of

CFX-9850G graph clear operation

Clears all channel settings and data.

Specifies sampling with Auto-ID probe con-

nected to CH1.

Specifies sample time of 0.5 seconds, 100

samples, and absolute time recording on.

Note the use of the display halt command

(^), which causes the calculator to wait until

the data analyzer finishes its sampling op-

eration before continuing with program ex-

ecution. Always use the display halt com-

mand (^) with Command 3.

Transfers time data to List 1.

Transfers CH1 data to List 2.

Sets up CFX-9850G statistical graph.

Turns off statistical graphs that are not be-

ing used.

Draws statistical graph on CFX-9850G.