User`s guide

12|CLABUser’sGuide

Tochargebattery
UseonlytheUSBcableandUSBpoweradapterdeliveredwithyourCLAB.
 ConnecttheUSBcabletotheminiUSBportofCLAB.
 ConnecttheotherendoftheUSBcabletoaUSBpoweradapter.
 PlugtheUSBpoweradapterinto
astandardpoweroutlet.
‐or‐
 ConnecttheUSBcabletotheminiUSBportofCLAB.
 ConnecttheotherendoftheUSBcableintoafreeUSBportofyourcomputer.
Notice,thattheefficiencyofchargingviaaUSBport,islimitedbythemaximal
current
 provided by a USB socket (500 mA for USB 2.0 and 800 mA for USB
3.0).
Toreplacebattery
Use only theapproved rechargeable batteries provided by CMA. To simplify the
battery replacement CMA provides a complete backside of CLAB (as shown in
photo)inwhichanewbatteryis
alreadyplaced.
 TurnCLABoff.
 Use a  small cross‐slotted (Philips
head) screwdriver to unscrew the
screwslocatedonthesidesofCLAB.
 Verycarefullymovethebacksideof
CLABoutofitshousing.Thebattery
is connected to the CLAB’s PCB
board via
a wire and the board
moves together with the plastic
part.
 Very carefully disconnect the
battery from the PCB by pressing
the battery plug and moving it out
of the battery connector on the
PCB.
 Move out the Power button from
the backside of CLAB. Notice that
this
button is made from three
plasticparts,whichcanfallapart.
 ConnectthenewbatterytothePCB
board by inserting the battery plug
into the battery connector on the
board.
