User`s guide

20031201
2-9
Basic Steps for Configuring Sampling Parameters
(9) Use the [Sample] and [Trigger] tabs of the Setup dialog box to configure the required
parameters.
• For details about the required parameters in each mode, see “Mode Parameters” on
page 3-5.
(10) To apply the current settings on the Setup dialog box, tap [Set].
• This closes the Setup dialog box.
(11) You can start sampling immediately or you can save the setup in memory for later
recall.
•To start sampling immediately, tap V.
See “5 Executing a Sampling Operation” for more information.
•To store the setup in memory, tap [SetupMem] on the menu bar, and then tap [Store].
See “4 Using Setup Memory” for more information.