Specifications

— 7 —
3.Load the backup battery (CR2032).
1Slide the battery cover switch to
BACK UP, and then remove the
backup battery cover.
2After wiping both side of a new lithium battery
(CR2032) with a dry cloth, place it into the
battery compartment with the positive side
facing up (so you can see it).
3Replace the backup battery cover and slide the battery cover switch back to LOCK.
4.Let the CASSIOPEIA rest for about five seconds, and then press the [Power] button.
•After a few moments the Microsoft Windows CE screen appears, press the [Action] control to
advance to the next screen.
5.Tap the cross marks that appear on the display to calibrate the touch screen.
•Tap the cross marks as they appear. After calibration is complete, press the [Action] control to
advance to the next screen.
6. Follow the instructions that appear on the screen to set your city, the current date, and the current
time.
•Microsoft Windows CE screen appears with a message telling that setup is complete. Tap the
screen to display the Active Desktop.
•See the Hardware Manual and Palm-size PC User's Guide for other information about operating
the CASSIOPEIA.
•Be sure to press the [Power] button to turn off power after you are finished using your CASSIO-
PEIA.
•You also need to install Windows CE Services before you can communicate with a desktop com-
puter.
Important
•If the touch panel does not respond when you tap it or if nothing appears on the display, try performing
a full reset (next page). If this does not restore proper operation, remove the main battery and the
backup battery and wait for about five minutes. Reload the main battery first and then the backup
battery, and perform the above procedure again from step 4.
•See 4-2. Battery Replacement for important information about replacing batteries.
•If the message "A problem with memory contents has been found..." appears on the display, perform
a full reset (next page).
Adjusting the Display
To do this: Perform this operation:
Make contrast darker [Exit] + Cursor up
Make contrast lighter [Exit] + Cursor down
Increase brightness [Exit] + Cursor right
Decrease brightness [Exit] + Cursor left