Specifications

— 56 —
13. DISASSEMBLY PROCEDURE
■ COMPONENTS
1. Position Battery cover switch on “MAIN” and
remove Rechargeable battery cover.
2. Pull Battery removal sheet and extract
Rechargeable battery.
3. Set Battery cover switch on “BACK UP” and
remove Backup battery cover.
4. Remove Backup battery.
5. Remove CF cover.
6. Pull out Stylus.
7. Remove 4 screw A's.
8. Displace Battery removal sheet.
9. Pulling stylus holder part of Upper case
outward and disengage the case hooks.
10. Unhook the opposite hooks by sliding Lower
case.
11. Remove IrDA filter.
12. Remove RS-232C cover.
13. Remove 2 screw B's on Backup battery PCB
located on Lower case. Separate Backup
battery PCB and Lower case.
14. Disconnect AUDIO PCB ass'y from the
connector and remove the PCB.
Note:
As the AUDIO PCB ass'y is stuck by adhesive
tape, be cautious when you peel it off.
15. Lift Inner case and disconnect FPC from KEY
PCB ass'y.
Stylus
CF cover
screw A
Backup battery cover
Rechargeable battery
Rechargeable battery coverBattery removal sheet
Battery cover switch
screw A
Battery removal sheet
screw B
IrDA filter
AUDIO PCB ASS'Y
RS-232C cover