Specifications

— 29 —
7-3. Operation Check
1. Perform 3-2. Initial Setup of this manual.
2. Install the diagnostic program to E-100/-105.
3. Tap Start, Settings, and Taskbar.
4. Select Auto hide, and then tap OK.
5. Press Contacts button while holding down
Power button. Refer to the right figure.
6. After performing this operation, the following
Main Menu appears in the LCD display.
In case of using Compact Flash memory card:
After this display appears, you may pull out its Compact Flash memory card.
Even if there are no Compact Flash memory card, this OPERATION CHECK can be performed because
the diagnostic program was already saved to D-RAM of E-100/-105.
** Main Menu **
1 DISPLAY
2 TOUCH PANEL
3 MEMORY
4 SERIAL
5 POWER CONTROL
6 AUDIO
7 Others
8 COLOR BAR
9 CAMERA
CPROG Rev. xxx for Jx-537
ITEM OPERATION DISPLAY
Tap 1 DISPLAY.
NOTE
Display
Power
Contacts
Medium RED