Specifications

R-148
Read and Reset
6. Read and reset operations
By setting the mode to the X or Z, the contents of totalizers and counters are enabled to read.
The X mode allows report at any time during business hours. The Z mode is only performed
at the end of the business day, since it clears the data stored to the totalizers and counters.
6-1. The procedures of reading or resetting
1. Sign on a clerk (if necessary).
2. Press <X/Z MODE> to assign X / Z report.
3. Select the appropriate menu you want by following the
guidances. The hierarchy of the X / Z menus are described
below.
Refer to page 108, 109 of this manual for X / Z command.
X/Z Report Daily X Batch Batch 1 ~ n (n = 1 ~ 10) (n: allocated batch number)
Cashier/Clerk Individual
All clerk
Open Check Individual
Clerk
All
Only total (X only)
All Information (X only)
E-journal All
Date & Consecutive number (X only)
Reset only (Z only)
Others Individual key (Daily X/Z only)
Flash (Daily X only)
Fixed totalizer
Free Function
PLU
PLU stock (Daily X/Z only)
Sub Department
Department
Group
Hourly sales
Monthly sales
Table analysis
Void
Hourly product
IDC IDC (1) clear (Z only)
IDC (2) clear (Z only)
IDC (3) clear (Z only)
Periodic 1 X Batch Same as Daily X
Cashier/Clerk Same as Daily X
Others Same as Daily X
Periodic 2 X Same as Periodic 1 X
Daily Z Same as Daily X
Periodic 1 Z Same as Periodic 1 X
Periodic 2 Z Same as Periodic 2 X
Time & Attendance Employee activity
Employee
Employee edit
Hourly Labor
X/Z C 01 15-12-96 12:34 000000
X/Z Report
1.Daily X
2.Periodic(1) X
3.Periodic(2) X
4.Daily Z
5.Periodic(1) Z
6.Periodic(2) Z
0.00