User manual

111
byMaxLength
This parameter is for specifying the maximum number of digits. Any bar code of Industrial
2of5 symbology with its length longer than the value set in this parameter will not be
decoded. Each default of the respective models is as follows.
• DT-X11
55 digits
• IT-600
67 digits
• DT-X7
67 digits
• IT-600M30U, IT-600M30UC, DT-X7M10U, and IT-300E-35E
50 digits
byCheckDigit
This parameter is for specifying designating the check digit selecting either of the values
listed below.
OBR_CHKDOFF : Without check digit calculation
OBR_CHKDON : With check digit calculation
byCheckChar
This parameter is for specifying check character selecting either of the values listed below.
OBR_CHKKOFF : Without check character output
OBR_CHKKON : With check character output
Return Values
OBR_OK : Normal end
OBR_PRM : Parameter error
OBR_PON : Open already
OBR_NOT_DEVICE : Scanner driver error. In the Device Emulator, this value is not returned.
FUNCTION_UNSUPPORT : Unsupported error
Note:
IT-600M30U, IT-600M30UC, DT-X7M10U, and IT-300E-35E do not support that the
settings for reading Industrial 2of5 and IATA symbologies are to be concurrently made
enabled. If it is done wrongly, all other settings for reading other symbologies are disabled
and a parameter error is returned.