User`s guide

5.5
ActiveSync
Connection
via
Ethernet
Cradle
This
chapter
describes
how
to
establish
a
high
speed
LAN
connection
on
the
WLAN
non-integrated
models (DT-X7M10E and DT-X7M10U) with HA-F62IO Ethernet cradle via ActiveSync 3.8 (see
note) or earlier.
Note:
Later versions of the Microsoft ActiveSync do not support this connection. Use version 3.8 or earlier
to establish the connection.
Follow
the
steps
below:
1. Establish partnership first between the DT-X7 and PC using any method so far described in this
guide (connection establishment via either IrDA, USB cradle or Ethernet cradle).
2. Connect the dedicated AC adapter to the Ethernet cradle as described in Chapter 4.2 .
3. Connect one end of the network cable to the Ethernet cradle and the other end to the network
hub.
4. Make sure the selector switch on the back of the HA-F62IO Ethernet cradle is set to the
position ”LAN”. See Figure 5.23 below.
Set
to
LAN
Figure
5.23
5. Place the DT-X7 in the cradle and navigate to Start → Settings → Control Panel →
Network and Dial-up Connections.
6. The following screen will appear. Double click the AX887721 icon. The icon will not appear
unless the terminal is set in the cradle.
Figure
5.24
36